Huawei SmartAX MA5603T Configuration Manual page 739

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
huawei(config)#traffic table ip index 8 cir 4096 priority 1 priority-
policy
local-setting
c.
Create a service port.
Set the service port indexes to 1 and 2, S-VLAN ID to 100, and C-VLAN ID to
10. The user PC is connected to EHT port 1 on the ONT. The traffic profile 8 is
used.
NOTICE
The user PC is connected to the ONT port. Therefore, the user-side VLAN is set
to untagged.
huawei(config)#service-port 1 vlan 100 port 0/1/1 ont 1 eth 1 multi-
service
user-vlan untagged inbound traffic-table index 8 outbound traffic-
table index 8
huawei(config)#service-port 2 vlan 100 port 0/1/1 ont 2 eth 1 multi-
service
user-vlan untagged inbound traffic-table index 8 outbound traffic-
table index 8
5.
Configure the voice service.
a.
Create an S-VLAN and add an upstream port to it.
The VlAN ID is 200, and the VLAN type is smart. Add upstream port 0/19/0 to
smart VLAN 200.
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/19 0
b.
Enable ARP proxy.
For different users of the same S-VLAN, because the service ports of the smart
VLAN are isolated from each other, the voice media streams cannot interchange
normally. The ARP proxy function of the OLT must be enabled so that different
users of the same VLAN can communicate with each other.
huawei(config)#arp proxy enable
huawei(config)#interface vlanif 200
huawei(config-if-vlanif200)#arp proxy enable
huawei(config-if-vlanif200)#quit
c.
Configure a traffic profile.
Run the display traffic table ip command to query existing traffic profiles in
the system. If the traffic profiles existing in the system do not meet the
requirements, you need to run the traffic table ip command to add a traffic
profile.
Set the profile ID to 9, the priority to 6 and no rate limitation on both the upstream
and downstream directions. In addition, configure the scheduling mode so that
packets are scheduled according to their priorities.
huawei(config)#traffic table ip index 9 cir off priority 6 priority-
policy
local-setting
d.
Create a service port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
714

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents