Huawei SmartAX MA5603T Configuration Manual page 899

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
Voice user
configuratio
n data
Common
Parameter
Procedure
Step 1 Log in to and configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. The user name
is root and the password is mduadmin.
Step 2 Configure the upstream VLAN interface.
Specify the upstream VLAN interface for the media stream and the signaling flows and configure
the IP addresses of the Layer 3 interface. These IP addresses are the sources of the IP address
pools for the media stream and the signaling flows.
1.
2.
3.
Step 3 Configure the media and signaling IP address pools.
Set the media IP address and signaling IP address to 10.10.10.10, and the media gateway to
10.10.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.10.10.10 10.10.10.1
huawei(config-voip)#ip address signaling 10.10.10.10
huawei(config-voip)#quit
Issue 01 (2014-04-30)
Profile index (SIP)
Phone number
User priority
User type
System parameter
Overseas parameter
PSTN port attribute
Ringing current attribute
Create an upstream VLAN.
The VLAN ID is 200 and the VLAN is a smart VLAN.
huawei(config)#vlan 200 smart
Add the upstream port to the created upstream VLAN.
Add upstream port 0/0/1 to VLAN 2000.
huawei(config)#port vlan 200 0/0 1
Configure the IP address of the Layer 3 interface.
Enter the VLAN interface mode and configure the lP address of the Layer 3 interface to
10.10.10.10
huawei(config)#interface vlanif 200
huawei(config-if-vlanif200)#ip address 10.10.10.10 24
huawei(config-if-vlanif200)#quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Data
1
83110001-83110024
Phone 1 indicates Cat2.
Phone 2 to phone 24 indicate Cat3 (default
value).
Common user (the DEL user by default)
Default value
Default value
Polarity-Reversing Pulse
Default value
874