Configuring The Voice Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

10.6.2.6 Configuring the Voice Service

The OLT is connected to the remote ONU through a GPON port to provide users with the IP-
based high-quality and low-cost VoIP service.
Prerequisites
l
l
l
l
l
Data Plan
Item
ONU line profile
Issue 01 (2014-04-30)
Parameter
VLANID
[1-4094]
Binding item
Mode
c. Click OK.
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
The SIP interface data and POTS user data corresponding to the MG interface have been
configured on the SIP server.
The connection between the OLT and the SIP server is set up. The OLT can ping the IP
address of the SIP server successfully.
The ONU has been added to the OLT. For details, see
OLT.
HGWs have different models and appearances but their configuration procedures are
similar. This topic uses the HG255 that uses LAN for upstream transmission as examples.
The IADs use SIP as the voice protocol.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
If VLAN enabling is set to Enabled, this parameter takes
the value of uservlan that is specified when you configure a
service flow for the Internet access service on the OLT.
LAN1 and LAN2: PCs connected to ports LAN1 and LAN2
can simultaneously access the Internet.
Bridge: PCs access the Internet through PPPoE dialup.
Data
Profile name: fttd
T-CONT ID: 4
GEM port ID: 12
10 FTTD Configuration
10.6.1.3 Adding an ONU to an
800