Huawei SmartAX MA5603T Configuration Manual page 380

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
huawei(config)#voip
huawei(config-voip)#ip address media 10.10.10.10 10.10.10.1
huawei(config-voip)#ip address signaling 10.10.10.10
huawei(config-voip)#quit
3. Add an MG interface.
Add an MG interface for the MG to communicate with the MGC, which ensures that
the MGC can control the call connection through the MG interface. According to the
data plan, add MG interface 0, and configure the interface attributes.
huawei(config)#interface h248 0
Are you sure to add MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#if-h248 attribute mg-media-ip1 10.10.10.10 mgip
10.10.10.10 mgport 2944 primary-mgc-ip1 10.10.20.20
primary-mgc-port 2944 code text transfer udp
4. Configure the TID template of the PSTN users on MG interface 0.
Configure the TID generation mode. According to the data plan, the terminal prefix
of PSTN users is huawei, and the TID template adopts layering template 6.
NOTICE
The MA5600T/MA5603T/MA5608T requires that the terminal prefixes of PSTN
users, ISDN BRA users, and ISDN PRA users on the same H.248 interface be either
the same or different. Note this when configuring the terminal prefix.
huawei(config-if-h248-0)#tid-format pstn prefix huawei template 6
5. Reset the MG interface.
Reset the MG interface to make the MG interface register with the MGC (and to make
the modified attributes of the MG interface take effect) so that the MG interface can
work in the normal state. The MG interface can be started in different ways (see
Parameters of the reset command). For a newly configured MG interface, enable the
MG interface through cold start.
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
6. Query the running status of the MG interface.
After the MG interface is interconnected with the MGC, the MG interface should be
in the normal state, indicating that the MG interface works in the normal state.
huawei(config)#display if-h248 all
-------------------------------------------------------------------------
-----
MGID Trans State
DomainName
-------------------------------------------------------------------------
-----
0 UDP
10.10.20.20
-------------------------------------------------------------------------
-----
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MGPort MGIP
Normal 2944
3 Configuring the DSLAM Services
MGCPort MGCIP/
10.10.10.10 2944
355