Huawei SmartAX MA5603T Configuration Manual page 544

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l Users of port 0/2/2 need to be authenticated, and have rights to watch two programs and to
preview one program.
l Users of port 0/2/3 do not need to be authenticated.
1.
2.
3.
Issue 01 (2014-04-30)
Configure the xDSL.
In this example, there is no need to configure the xDSL. The default line profile (profile
1002) is used.
Configure the VLAN.
l Create a VLAN.
huawei(config)#vlan 100 smart
l Configure the VLAN upstream port.
huawei(config)#port vlan 100 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
limit
Are you sure to add standard port(s)? (y/n)[n]:y
l Configure the native VLAN.
NOTE
When the VLAN ID of the tag packet is the same as the VLAN ID of the native VLAN of the egress,
the egress removes the tag of the packet. That is, the tagged packet becomes to the untagged packet
(without VLAN ID) after the tagged packet passes through the egress.
huawei(config)#interface giu 0/19
huawei(config-if-giu-0/19)#native-vlan 0 vlan 100
huawei(config-if-giu-0/19)#native-vlan 1 vlan 100
l Create the traffic profile.
huawei(config)#traffic table ip index 8 cir off priority 5 priority-policy
local-Setting
l Add ADSL2+ ports 0/0/2 and 0/0/3 to VLAN 100.
huawei(config)#service-port vlan 100 adsl 0/2/2 vpi 0 vci 35 rx-cttr 8 tx-
cttr 8
huawei(config)#service-port vlan 100 adsl 0/2/3 vpi 0 vci 35 rx-cttr 8 tx-
cttr 8
Configure the multicast service.
l Enable the multicast proxy function.
huawei(config)#multicast-vlan 100
huawei(config-mvlan100)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
l Set the upstream port.
huawei(config-mvlan100)#igmp uplink-port 0/19/0
huawei(config-mvlan100)#quit
huawei(config)#btv
huawei(config-btv)#igmp uplink-port-mode default
Are you sure to change the uplink port mode?(y/n)[n]:y
l Set the preview parameters.
In this example, configure the preview authority profile with the preview duration
for the program to 150s, the number of preview attempts to 6 each day and the
preview interval to 60s.
huawei(config-btv)#igmp preview-profile add index 1 duration 150 times 6
interval 60
huawei(config-btv)#igmp preview auto-reset-time 00:00:00
huawei(config-btv)#quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Example: Subtending Networking
519