Huawei SmartAX MA5603T Configuration Manual page 502

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
Step 8 Configure the SHDSL service.
The MA5600T/MA5603T/MA5608T supports the SHDSL service of multiple encapsulation
modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example
to describe how to configure the SHDSL service. For other encapsulation modes, see
Example: Configuring the xDSL Internet Access
Issue 01 (2014-04-30)
huawei(config)#adsl line-template add 10
Start adding template
Press 'Q' to quit the current configuration and new configuration will be
neglected
> Do you want to name the template (y/n) [n]:
> Please set the line-profile index (1~128) [1]:10
> Will you set channel configuration parameters? (y/n) [n]:y
> Please set the channel number (1~2) [1]:1
> Channel1 configuration parameters:
> Please set the channel-profile index (1~128) [1]:10
Add template 10 successfully
Configure the ADSL2+ alarm profile.
You can configure the ADSL2+ alarm profile based on your requirements. For details on
the configuration, see "Configuring an ADSL2+ Alarm Template." In this example, the
default alarm profile (template 1) is used.
Configure the ADSL2+ traffic profile.
You can configure the ADSL2+ traffic profile by running the traffic table ip command
based on your requirements.
In this example, the default profile (profile 6) is used.
Activate the ADSL2+ port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate all
huawei(config-if-adsl-0/2)#alarm-config all 1
huawei(config-if-adsl-0/2)#activate all template-index 10
huawei(config-if-adsl-0/2)#quit
Configure the upstream port.
l Configure the GIU board.
The configuration of the upstream port of the GIU board should be the same as the
configuration of the peer device.
Run the auto-neg command to set the port to work in the auto-negotiation mode.
If the port does not work in the auto-negotiation mode, change to the GIU config
mode and run the speed command to change the port rate, and run the duplex
command to change the port duplex mode.
l Configure the VLAN.
The ADSL2+ users of MA5600T/MA5603T/MA5608T-4 adopt the PPPoE
authentication. In this case, the smart VLAN is used to identify the users.
huawei(config)#vlan 2040 smart
huawei(config)#port vlan 2040 0/19 0
Add the service port.
All ports in slot 0/2 provide the ADSL2+ service. To add service ports in batches, run the
multi-service-port command.
huawei(config)#multi-service-port vlan 2040 port 0/2 0-31 vpi 0 vci 35
rx-cttr 6 tx-cttr 6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Example of MSTP Subtending Network
Service."
"3.1
477