Huawei SmartAX MA5603T Configuration Manual page 508

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
5.
6.
7.
Step 3 Configure the time server.
huawei(config)#ntp-service unicast-server 4.4.4.4 source-interface vlanif 10
huawei(config)#ntp-service unicast-server 4.4.4.5 source-interface vlanif 10
Step 4 Configure the log host.
huawei(config)#loghost add 3.3.3.3 syslog-1
huawei(config)#loghost activate ip 3.3.3.3
huawei(config)#loghost add 3.3.4.3 syslog-2
huawei(config)#loghost activate ip 3.3.4.3
Step 5 Configure the EMU.
This topic uses the fan and the PS4875L power supply as an example to describe how to configure
the EMU.
By default, the default slave node number of the fan EMU is 0. In this example, assume that the
slave node number is 1. In this case, you need to set the DIP switch of the node address on the
fan monitoring unit as 1.
huawei(config)#emu add 0 power4875l 0 0
huawei(config)#emu add 1 fan 0 1
huawei(config)#interface emu 0
huawei(config-if-power4875l-0)#power module-num 2 1 2
huawei(config-if-power4875l-0)#quit
Step 6 Configure the VDSL2 service.
The MA5600T/MA5603T/MA5608T supports the VDSL2 Internet service of multiple
encapsulation modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode
as an example to describe how to configure the VDSL2 service. For other encapsulation modes,
see "3.1 Example: Configuring the xDSL Internet Access
1.
Issue 01 (2014-04-30)
l Configure the device local information.
huawei(config)#snmp-agent sys-info location Shenzhen China
l Configure the SNMP version.
The SNMP version must be the same as the SNMP version of the NMS. In this
example, the NMS version is set as SNMP V2C.
huawei(config)#snmp-agent sys-info version v2c
Enable the trap sending.
huawei(config)#snmp-agent trap enable standard
Set the trap destination address.
huawei(config)#snmp-agent target-host trap-hostname huawei address 2.2.2.2
trap-paramsname abc
huawei(config)#snmp-agent target-host trap-hostname huawei123 address 2.2.2.3
trap-paramsname 123
Set the trap source address.
huawei(config)#snmp-agent trap source vlanif 10
Configure the VDSL2 line profile.
You can configure the VDSL2 line profile based on your requirements.
huawei(config)#vdsl line-profile add 10
Start adding
profile
Press 'Q' to quit the current configuration and new configuration will
be
neglected
> Do you want to name the profile (y/n)
[n]:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Example of MSTP Subtending Network
Service."
483