Huawei SmartAX MA5603T Configuration Manual page 342

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
In this example, the device runs in China. The default configurations of system parameters and
the overseas feature parameters meet the standard and the application requirements. Therefore,
you do not need to configure these parameters.
Table 3-5
Table 3-5 Data plan for configuring the VoIP PSTN service (SIP)
Item
SIP interface
data
(The data
configuration
on the SIP
interface must
be the same as
the data
configuration
on the IMS.)
Issue 01 (2014-04-30)
provides the data plan for configuring the VoIP PSTN service (SIP).
Media and Media and
signaling signaling
parameter upstream VLAN
s
Media and
signaling
upstream port
Media and
signaling IP
addresses
SIP The SIP interface
interface ID
(SIP)
NOTE
The
parameter
s of the
Signaling port ID
SIP
of the SIP
interface
interface
must be
the same
IP address of the
as the
primary
parameter
softswitch to
s on the
softswitc which the SIP
h. SIP has
interface belongs
many
negotiatio
Port ID of the
n
primary
parameter
softswitch to
s, and the
which the SIP
parameter
interface belongs
s here are
mandator
y.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Data
Standard VLAN is recommended as the
upstream VLAN of the VoIP service.
Standard VLAN 20 is adopted.
In this office, all the services are
transmitted upstream through the GIU
board. Therefore, port 0/19/0 is used as
the upstream port of the VoIP service.
Next hop address from the MA5600T/
MA5603T/MA5608T to the IMS core
network device.
NOTICE
If the media IP address and the signaling IP
address are different and the media and the
signaling are transmitted upstream through
different gateways, ensure that they
correspond to correct gateways. Otherwise,
normal calls may not be made.
0
It is the SIP interface ID used for the
VoIP service to be configured, which
determines the virtual access gateway
(VAG) specified for the user.
5060
IP address: 10.10.10.20/24
Port ID: 5060
When dual homing is configured, the IP
address and the port ID of the secondary
softswitch must also be configured.
317