Huawei SmartAX MA5603T Configuration Manual page 427

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
Tunnel
OSPF
PWE3
gateway
Table 4-4 Plan for configuring attributes of each type of service
Item
Board
Slot
VPI/
VCI of
Cells
Bindin
g PW
ID
Issue 01 (2014-04-30)
Data
Tunnel ID: 20; tunnel interface ID:
20
Encapsulation protocol of the tunnel
interface at the data link layer:
MPLS IP
Source IP address of the tunnel:
5.5.5.5
Destination IP address of the tunnel:
7.7.7.7
OSPF process ID: 200; OSPF area
ID: 1
LSR ID: 7.7.7.7
service Type
UBR VBR
0/2 0/3
0/35 0/35
20 21
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
Remarks
IP tunnels are used.
Ingress and egress addresses of a
tunnel are the LSR IDs of the local
device and the peer PE device,
respectively.
Routes use the OSPF protocol.
It is the LSR ID of the peer PE
device.
Remarks
CBR
0/4 Multiple services of the same type
but from different users are
deployed at different ports on the
same board (in the same slot). By
doing so, the same PW is used to
carry multiple PVCs. This
improves the transmission
efficiency, reduces the number of
PWs required, and facilitates the
application of QoS policies.
Services of different types are
deployed on boards in different
slots, isolating the services
physically.
0/35 Since the services belong to the
same ISP, the VPI/VCI parameters
of cells on PVCs at different ports
are the same.
22 Services of different types are
carried over different PWs,
eliminating service interaction.
402