Huawei SmartAX MA5603T Configuration Manual page 724

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
Issue 01 (2014-04-30)
Configure the multicast forwarding mode is untagged.
huawei(config)#ont-srvprofile gpon profile-name ftth
huawei(config-gpon-srvprofile-1)#multicast-forward untag
huawei(config-gpon-srvprofile-1)#commit
huawei(config-gpon-srvprofile-1)#quit
Configure the VLAN of the Ethernet port on the ONT.
If the ONT is connected to the STB through Ethernet port 2, add Ethernet port 2 to VLAN
1000.
huawei(config)#ont-srvprofile gpon profile-name ftth
huawei(config-gpon-srvprofile-1)#port vlan eth 2 1000
huawei(config-gpon-srvprofile-1)#multicast-forward untag
huawei(config-gpon-srvprofile-1)#commit
huawei(config-gpon-srvprofile-1)#quit
Create service flows.
Set the service VLAN to 1000, GEM port ID to 13, and user VLAN to 1000, and use traffic
profile 8.
huawei(config)#service-port 1 vlan 1000 gpon 0/1/0 ont 1 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
huawei(config)#service-port 2 vlan 1000 gpon 0/1/0 ont 2 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
Create an MVLAN and configure the IGMP version.
Set the IGMP version for the MVLAN to IGMPv2.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v2
This operation will delete all IPv4 programs with source IP addresses in the
current multicast VLAN
Are you sure to change current IGMP version? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
Configure a program library.
Set the mode for obtaining multicast programs to dynamic.
NOTE
You can set the mode for obtaining multicast programs to dynamic only when the IGMP mode is off.
huawei(config-mvlan1000)#igmp mode off
Are you sure to close IGMP? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
huawei(config-mvlan1000)#igmp match mode disable
Command has been executed successfully
(Optional) Set the address range for the dynamic programs. If you need to limit the address
range of dynamic programs, perform this operation. For example, set the address range of
dynamic programs to 224.1.1.1-224.1.1.100.
huawei(config-mvlan1000)#igmp match group ip 224.1.1.1 to-ip 224.1.1.100
Set the IGMP mode.
Select the IGMP proxy mode.
huawei(config-mvlan1000)#igmp mode proxy
Are you sure to change IGMP mode? (y/n)[n]:y
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
699