Commissioning Inband Network Management (Snmp V3) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

1.4.1.4 Commissioning Inband Network Management (SNMP V3)

This topic describes how to implement the inband network management on the MA5600T/
MA5603T/MA5608T through the upstream port (inband network management port). This
enables the U2000 to maintain the MA5600T/MA5603T/MA5608T through this management
channel. In the inband network management mode, the service channel of the device is used to
transmit the management information. The network is flexible and requires no additional
devices, which helps save the cost for carriers. This network, however, is difficult to maintain.
Service Requirements
In the network as shown in
l
l
l
l
Figure 1-66 Example network for the inband network management
=
Access node
VLAN:1000
10.50.1.10/24
Figure 1-67
Issue 01 (2014-04-30)
Figure
The MA5600T/MA5603T/MA5608T provides the inband network management through
the upstream port.
The upstream port of the GIU board on the MA5600T/MA5603T/MA5608T is used as the
inband network management port.
A static route is used between the MA5600T/MA5603T/MA5608T and the U2000.
SNMP V3 is used (more reliable than V1 and V2, providing network security and access
control management functions).
shows the flowchart for commissioning the inband network management.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-66, the service requirements are as follows:
Router
10.50.1.1/24
1 Commissioning
U2000
10.10.1.10/24
156