Huawei SmartAX MA5603T Configuration Manual page 417

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Table 4-1 Data plan for configuring the QinQ VLAN private line service
Item
VLAN
Transparent
transmission of
Layer 2 packets
Upstream port
Traffic profile
VDSL2 port
Service virtual
port
Issue 01 (2014-04-30)
Data
l VLAN ID: 50
l VLAN type: smart VLAN
l VLAN attribute: QinQ
Enable the transparent transmission of
BPDUs.
0/19/0
l Traffic profile ID: 10
l CIR: 4 Mbit/s
l Priority copy policy: user-cos
l Default 802.1p priority of the packet: 4
l Priority-based scheduling policy of the
downstream packets: local-setting
l VDSL2 port ID: 0/2/0
l Default VDSL2 line profile: 1
l Default VDSL2 alarm profile: 1
l VLAN ID: 50
l Service port: 0/2/0
l VDSL channel mode: ATM
l VPI: 0
l VCI: 35
l ID of the traffic profile in Rx direction:
10
l ID of the traffic profile in Tx direction:
10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
Remarks
The public network VLAN,
namely outer VLAN, is
configured here. The inner
VLAN belongs to the
enterprise private network,
which can be planned by the
enterprise self.
This function is mainly used
in the QinQ service to
provide a transparent and
secure data channel for the
enterprise branches located
in two places within the
enterprise private network.
After the transparent
transmission of BPDUs is
enabled, the Layer 2 protocol
packets of a private network
can be transparently
transmitted through the
public network.
-
The CIR depends on the user
bandwidth requirement.
-
l The VPI/VCI is the same
as the management VPI/
VCI on the peer modem.
l The traffic profile that
meets the service
requirement is used.
392