Huawei SmartAX MA5603T Configuration Manual page 316

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 8 Configure a service port.
Run the display service-port command to query the original service port.
huawei(config)#display service-port port 0/2/4
{ <cr>|autosense<K>|ont<K>|sort-by<K> }:
Command:
Switch-Oriented Flow List
----------------------------------------------------------------------------
INDEX VLAN VLAN
----------------------------------------------------------------------------
----------------------------------------------------------------------------
Total : 1
The query result shows that VPI and VCI are configured, which indicate that VDSL is in the
ATM mode. In this example, however, the VDSL is in the PTM mode. Run the service-port
command to create a service port, adopt traffic profile 7, and set the S-VLAN ID to 101. Set the
index of the service port to 3 (the index must be different from the original index) and the access
port to 0/2/4. To facilitate maintenance of the service port, configure the service port description.
NOTE
Generally, the ADSL is in the ATM mode and the VDSL is in the PTM mode. If an ATM service port only is
configured, a PTM service port needs to be added.
huawei(config)#service-port 3 vlan 101 vdsl mode ptm 0/2/4 rx-cttr 7 tx-cttr 7
huawei(config)#service-port desc 3 description Vlanid:101/vdsl/ptm
Step 9 Save the data.
huawei(config)#save
----End
Verification
l
Issue 01 (2014-04-30)
2 512 18384
3 576 20432
4 64 4048
5 2048 67536
6 off off
---------------------------------------------------------------------------
Total Num : 7
According to customer requirements, the user access rate is 8192 kbit/s. The query result
shows that no traffic profile meets customer requirements. Therefore, run the traffic table
ip command to configure a new traffic profile (traffic profile 7) and set the rate to 8192
kbit/s in the new traffic profile.
NOTE
You can configure the traffic profile or the VDSL2 line profile on the MA5600T/MA5603T/MA5608T
to limit the user access rate. When both profiles are configured, the bandwidth of the user is the minimum
value of the two profiles. In this example, the traffic profile is used to limit the user access rate.
huawei(config)#traffic table ip index 7 cir 8192 priority 6 priority-policy
local-Setting
display service-port port 0/2/4
PORT F/ S/ P VPI
ID ATTR TYPE
5 101 common vdl
(Up/Down :
Step 1: Configure the user name and password for the dialup on the modem (the user name
and password must be the same as those configured on the BRAS).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1024 36768
1152 40864
128 8096
4096 135072
off off
VCI FLOW
TYPE
0/2/4 0 35 vlan
1/0)
3 Configuring the DSLAM Services
0 -
2 -
4 -
0 -
0 -
FLOW RX TX
PARA
untag 6 6
tag-pri
tag-pri
tag-pri
tag-pri
tag-pri
STATE
up
291