Huawei SmartAX MA5603T Configuration Manual page 192

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
NOTE
Step 2 Configure the media and signaling IP address pools.
The media and signaling IP addresses are 10.50.1.10/24, and the gateway IP address is 10.50.1.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.50.1.10 10.50.1.1
huawei(config-voip)#ip address signaling 10.50.1.10
huawei(config-voip)#quit
NOTE
Step 3 Configure a static route to the MGC.
The IP address of the destination network segment of the static route to the MGC is 10.10.1.0/24,
and the gateway IP address is 10.50.1.1.
huawei(config)#ip route-static 10.10.1.0 255.255.255.0 10.50.1.1
Step 4 Add an MG interface.
MG interface 0 that supports the H.248 protocol is added.
huawei(config)#interface h248 0
Are you sure to add MG interface?(y/n)[n]:y
Step 5 Configure the attributes of the MG interface.
The media and signaling IP addresses of the MG interface are 10.50.1.10/24, the MG port ID is
2944, the coding mode is text, the transmission mode is UDP, the MG domain name is
MA5600T/MA5603T/MA5608T.com, the IP address of the primary MGC is 10.10.1.4/24, the
MGC port ID is 2944, and the start negotiation version of the H.248 is V2.
huawei(config-if-h248-0)#if-h248 attribute mgip 10.50.1.10 mgport 2944 code text
transfer udp domainName
MA5600T/MA5603T/MA5608T.com primary-mgc-ip1 10.14.1.4 primary-mgc-port 2944 mg-
media-ip1 10.50.1.10 start-negotiate-version 2
NOTE
Step 6 Reset the MG interface.
The MG interface is reset through cold start.
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
Step 7 Save the data.
huawei(config)#save
----End
Result
After the MG is interconnected with the MGC successfully, you can run the display if-h248
all command to confirm that the MG interface is in the normal state.
huawei(config)#display if-h248 all
-------------------------------------------------------------------------
MGID
-------------------------------------------------------------------------
Issue 01 (2014-04-30)
If the packet transmitted from the upstream port is untagged, run the native-vlan command to configure
the native VLAN of the upstream port to be the same as the VLAN of the upstream port.
When configuring the MG interface attributes, ensure that the media and signaling IP addresses exist in
the corresponding address pools.
The start negotiation version of the H.248 protocol for the MG interface must be the same as that on the
MGC side.
TransMode State
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MGPort MGIP/DomainName MGCPort MGCIP/DomainName
1 Commissioning
167