Huawei SmartAX MA5603T Configuration Manual page 549

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3.
4.
5.
6.
7.
8.
Step 8 Configure the SHDSL service.
Issue 01 (2014-04-30)
Configure the ADSL2+ line template.
Bind the configured line profile and channel profile together to form line template 10.
huawei(config)#adsl line-template add 10
Start adding template
Press 'Q' to quit the current configuration and new configuration will be
neglected
> Do you want to name the template (y/n) [n]:
> Please set the line-profile index (1~128) [1]:10
> Will you set channel configuration parameters? (y/n) [n]:y
> Please set the channel number (1~2) [1]:1
> Channel1 configuration parameters:
> Please set the channel-profile index (1~128) [1]:10
Add template 10 successfully
Configure the ADSL2+ alarm profile.
You can configure the ADSL2+ alarm profile based on your own needs. For details, see
"Configuring an ADSL2+ Alarm Template." In this example, the default alarm profile
(template 1) is used.
Configure the ADSL2+ traffic profile.
To configure the ADSL2+ traffic profile, run the traffic table ip command.
In this example, the default profile (profile 6) is used.
Activate the ADSL2+ port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate all
huawei(config-if-adsl-0/2)#alarm-config all 1
huawei(config-if-adsl-0/2)#activate all 10
huawei(config-if-adsl-0/2)#quit
Configure the upstream port.
l Configure the GIU board.
By default, the GE optical port of the GIU board works in the full duplex mode with
the rate of 1000 Mbit/s.
To change the port working mode and the port rate, run the speed and duplex
commands in GIU mode.
The settings must be the same as the settings of the peer device.
l Configure the VLAN.
The ADSL2+ users of MA5600T-1 use the VLAN authentication. In this case, the
smart VLAN is used to identify the users.
huawei(config)#vlan 2020 smart
huawei(config)#port vlan 2020 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
limit
Are you sure to add standard port(s)? (y/n)[n]:y
Add the service port.
All ports in slot 0/2 provide the ADSL2+ service. To add service ports in batches, run the
multi-service-port command.
huawei(config)#multi-service-port vlan 2020 port 0/2 0-31 vpi 0 vci 35 user-
encap pppo
rx-cttr 6 tx-cttr 6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Example: Subtending Networking
524