Huawei SmartAX MA5603T Configuration Manual page 333

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
l
Configuration File
The following describes the configuration file of this configuration example. Note that certain
steps must be performed manually and the configuration file cannot be imported directly.
Configure the upstream VLAN interface.
vlan 20 standard
port vlan 20 0/19 0
interface vlanif 20
ip address 10.10.10.10 24
quit
Configure the media and signaling IP address pools.
voip
ip address media 10.10.10.10 10.10.10.1
ip address signaling 10.10.10.10
quit
Add an MG interface and configure the attributes of the MG interface. The MG interface must
be configured manually, and the configuration profile cannot be directly imported.
interface h248 0
if-h248 attribute mg-media-ip1 10.10.10.10 mgip 10.10.10.10 mgport 2944 primary-
mgc-ip1 10.10.20.20
primary-mgc-port 2944 code text transfer udp
Configure the ringing mapping of the MG interface.
mg-ringmode add 0 0 4
Configure the TID format of the PSTN user on the MG interface.
tid-format pstn prefix huawei template 6
Enable the MG interface. The MG interface must be enabled manually, and the configuration
profile cannot be directly imported.
reset coldstart
quit
Query the running status of the MG interface.
display if-h248 all
Confirm the service board.
board confirm 0/3
Configure the PSTN user data.
esl user
mgpstnuser batadd 0/3/0 0/3/31 0
quit
Configure the polarity reversal accounting function.
Issue 01 (2014-04-30)
When the caller dials the phone number of the callee, the phone of the callee can ring
normally, and the caller can hear the ring back tone.
The caller and the callee can communicate with each other successfully.
After the callee hangs up the phone, the caller can hear the busy tone.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
308