Huawei SmartAX MA5603T Configuration Manual page 702

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
b. Select User 1 under the User node. In the right pane, set User Enabled to
Enable, and Interface ID to 1. Then, select User 2 under the User node.
In the right pane, set User Enabled to Enable, and Interface ID to 2.
NOTE
If Interface ID is 1, port TEL1 on the ONT is bound. If Interface ID is 2, port TEL2
on the ONT is bound.
h. Click Next.
i. In the dialog box that is displayed, set vendor ID to HWTC, Terminal Type to
General Type, and Version to V1R003C00-ZZ, click Add.
j. In the dialog box that is displayed, set the parameters.
– Choose General Type Config Info > Services > Voice Service > Voice
Service 1 > Interface Configuration > Interface 1 from the navigation tree,
and set Region to China.
– Choose General Type Config Info > WAN Device > WAN Device 1 >
WAN Connection > WAN Connection 1 > WAN IP Interface > WAN IP
Interface 1 from the navigation tree, and set WAN Interface Name to ONT-
VoIP, Service Type to VOIP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
677