Huawei SmartAX MA5603T Configuration Manual page 762

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
NOTE
must be
consistent
with the
data on the
MGC/IMS
core
network
devices.
Voice user
data
Issue 01 (2014-04-30)
Media IP
addresses and
signaling IP
addresses
Default gateway
IP address.
MG interface/SIP interface ID None
Signaling port ID
IP address of active MGC (H.
248)/IP address of active IMS
device (SIP)
Port ID of active MGC (H248)/
port ID of active IMS device
(SIP)
Coding
Transmission mode
Home domain (SIP)
Profile index
The version of H248 protocol
that MG starts to negotiate
Phone number
Terminal ID (H248)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 FTTD Configuration
Description
Supports separating media from signaling.
The next hop IP address from an ONU/HGW
to an MGC/IMS.
Choose the transmission mode according to
the requirement of the MGC/IMS side.
If the dual homing is not configured, only one
MGC parameter needs to be configured. If
the dual homing is configured, the IP address
and port ID of the standby MGC need to be
configured.
Choose the coding method according to the
requirement on the MGC/IMS side.
Generally, the text coding method is adopted.
Choose the transmission mode according to
the requirement on the MGC/IMS side.
Generally, the UDP transmission mode is
adopted.
None
None
V1, V2 or V3 (by default). The interface may
fail to be registered because some
softswitches do not support V3.
For H248 protocol: The phone numbers
allocated by the MGC need to be determined,
and the paging numbers for users' emergency
standalone need to be planned if the
emergency standalone function is provided.
For SIP protocol: The phone number that the
IMS core network device allocates to the user
must be configured.
If the TID template with which the POTS
user is bound does not support terminal
layering, this parameter needs to be
configured.
737