Huawei SmartAX MA5603T Configuration Manual page 378

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Dataplan
Table 3-15 Data plan of VAG1
Item
MG interface
data
(The data
configuration
must be the
same as the data
configuration
on the MGC.)
Issue 01 (2014-04-30)
Media and Media and
signaling signaling
parameter upstream VLAN
s
Media and
signaling
upstream port
Media IP address
and signaling IP
addresses
Default gateway
IP address
Attributes MG interface ID
of the MG
Signaling port ID
interface
of the MG
NOTE
interface
Parameter
s listed
IP address of the
here are
primary MGC to
mandator
which the MG
y, which
means interface belongs
that the
Port ID of the
MG
interface
primary MGC to
fails to be
which the MG
enabled if
interface belongs
these
parameter
Coding mode of
s are not
the MG interface
configure
d.
Transmission
mode of the MG
interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Data
Standard VLAN is recommended as the
upstream VLAN of the voice service.
Standard VLAN 20 is adopted.
In this office, all the services are
transmitted upstream through the
upstream interface board. Therefore,
port 0/19/0 is used as the upstream port
of the voice service.
These two IP addresses are both
10.10.10.10.
The IP address of the next hop from the
MA5600T/MA5603T/MA5608T to the
MGC is 10.10.10.1.
0 and 1
2944
The IP address of the primary MGC is
10.10.20.20, and the port ID is 2944, the
same as the port ID on the MA5600T/
MA5603T/MA5608T.
text (indicates the text coding mode)
UDP
353