Configuring The Environment Monitoring Parameters Of The Etp4890 - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config-if-smu-1)#quit
huawei(config)#save

1.3.16.8 Configuring the Environment Monitoring Parameters of the ETP4890

This topic describes how to configure the environment monitoring parameters of the ETP4890
through the CLI.
Mapping Between Monitoring Parameters and Device Ports
The ETP4890 monitoring scheme can be used in the F01D500 cabinet.
the mapping between the monitoring parameters displayed
NOTE
Table 1-36 Mapping between the monitoring parameters displayed on the host and the ports on
the sensor transfer box
Monitoring Parameter
Displayed on the Host
Digital 0
Digital 1
Digital 2
Digital 3
Digital 4
Digital 5
Digital 6
Door alarm
Wiring alarm
Battery Tem
environment Tem
Issue 01 (2014-04-30)
Before adding a user-defined analog or monitoring digital parameter, make sure that the port corresponding
to this parameter is properly connected to an environment monitoring cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Device Port
JTD1
JTD2
JTD3
JTD4
JTD5
JTD6
JTD7
JTM1
JTP1
VBTEM2
VTEM2
1 Commissioning
Table 1-36
Application in the F01S300
Cabinet
Not connected by default, used to
add a user-defined monitoring
digital parameter
Not connected by default, used to
add a user-defined monitoring
digital parameter
Not connected by default, used to
add a user-defined monitoring
digital parameter
Surge protector (SPD)
Not connected by default, used to
add a user-defined monitoring
digital parameter
Heat exchanger
Door status sensor of the MDF
compartment
Door status sensors of the device
compartment and heat exchanger
compartment
MDF
Battery temperature sensor
Environment temperature sensor
describes
115