Huawei SmartAX MA5603T Configuration Manual page 440

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Networking
Figure 4-5
1.
2.
3.
4.
5.
6.
Figure 4-5 Example network of the ETH PWE3
LAN Switch
Router
Data Plan
Table 4-6
Table 4-6 Data plan for configuring the ETH PWE3
Item
MPLS
VLAN
Issue 01 (2014-04-30)
shows an example network of the ETH PWE3.
The Ethernet switch or router of the enterprise aggregates the private network data of the
enterprise and sends the data to the ETH board of the MA5600T/MA5603T/MA5608T.
The control board sends ETH packets to the SPUB board.
After performing the PW and MPLS encapsulation for the packets, the SPUB board
performs the ETH packet header encapsulation and then sends them to the control board.
The control board performs the Layer 2 forwarding and sends the packets to the upstream
port.
The packets are sent over the MPLS network to the peer PWE3 gateway (such as the PTN).
The PWE3 gateway restores ETH signals and sends them to the peer Ethernet switch or
router.
Access
FE/GE
Node
FE/GE
lists the data plan for configuring the ETH PWE3.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
MPLS
Network
ETH PWE3
Data
LSR ID: 5.5.5.5
Global MPLS TE: enabled
MPLS Layer 2 VPN: enabled
VLAN MPLS RSVP-TE: enabled
Standard VLAN for MPLS forwarding: 200
IP address of the VLAN interface: 192.168.1.10
Upstream port: 0/19/0
LAN Switch
PWE3
Gateway
FE/GE
Router
FE/GE
415