Configuring The Iptv Service (On The Onu) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
NOTE
l To configure the data of a single SIP PSTN user, run the sippstnuser add command.
l To configure the data of multiple SIP PSTN users in batches, run the sippstnuser batadd command.
huawei(config)#esl user
huawei(config-esl-user)#sippstnuser batadd 0/3/0 0/3/23 0 telno 83110001
Step 10 Configure call priorities for SIP PSTN users.
huawei(config-esl-user)#sippstnuser attribute set 0/3/0 priority cat2
huawei(config-esl-user)#quit
Step 11 Configure all the PSTN ports to support polarity reversal.
Configure the physical attributes of the PSTN port to which the users belong to support polarity
reversal so that the user supports polarity reversal accounting.
huawei(config)#pstnport
huawei(config-pstnport)#pstnport attribute batset 0/3/0 0/3/23 reverse-pole-pulse
enable
huawei(config-pstnport)#quit
Step 12 Save the data.
huawei(config)#save
----End

11.3.3.12 Configuring the IPTV Service (on the ONU)

This topic describes how to configure the video on demand (VoD) service and multicast service
for home gateway (HGW) users on an optical network unit (ONU) when HGWs are connected
upstream to the ONU through local area networks (LANs) or in xDSL mode.
Data Plan
The following table provides key information about the IPTV service.
Item
Traffic
profile
User
VLAN in
the scenario
in which
HGWs are
upstream
connected
to an ONU
through
LANs
Issue 01 (2014-04-30)
Data
ID: 10
CIR: off
VLAN priority: 4
Downstream priority policy:
local-setting
User VLAN ID: 1, 2, 3...
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Remarks
-
HGWs can send untagged packets or packets
with user VLAN tags.
959