Configuring Sip Voice Service (On The Onu) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config)#save
----End

11.3.2.10 Configuring SIP Voice Service (on the ONU)

This topic describes how to configure voice services based on the Session Initiation Protocol
(SIP) on an optical network unit (ONU). The voice over IP (VoIP) services have high quality,
but require low cost.
Prerequisites
l
l
Precautions
1.
2.
This operation interrupts the ongoing services carried on the currently used MG interface. Hence,
exercise caution when performing this operation.
Data Plan
For configuration rules and description of configuration items, see
Service Data
Item
SIP
interface
data
NOTE
(It must be
the same as
that on the
IMS core
network
device.)
Issue 01 (2014-04-30)
The IP Multimedia Subsystem (IMS) interface data and public switched telephone network
(PSTN) user data corresponding to the SIP interface is configured on the IMS.
Status of the voice board on the ONU is normal. (To verify board status, run the display
board 0 command.)
An ONU supports both the H.248 and SIP protocols; however, these two protocols are
mutually exclusive. You can run the display protocol support command to query the
currently supported voice protocol.
If the voice protocol needs to be switched, you need to delete the MG interface first and
run the protocol support command to switch the protocol. After the configuration is
complete, save the configuration and restart the system to make the configured protocol
take effect.
CAUTION
Plan.
Media Media and
and signaling upstream
signalin VLAN
g
Media and
paramet
signaling upstream
ers
port
Media IP address
and signaling IP
address
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
11.2.5 Principle of VoIP
Data
200
0/0/1
10.10.10.10/24
912