Huawei SmartAX MA5603T Configuration Manual page 740

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
Set the service port indexes to 3 and 4, S-VLAN ID to 200, and C-VLAN ID to
20. The user phone is connected to the POTS port on the ONT. The traffic profile
9 is used.
huawei(config)#service-port 3 vlan 200 port 0/1/1 ont 1 iphost multi-
service
user-vlan 20 inbound traffic-table index 9 outbound traffic-table
index 9
huawei(config)#service-port 4 vlan 200 port 0/1/1 ont 2 iphost multi-
service
user-vlan 20 inbound traffic-table index 9 outbound traffic-table
index 9
6. Configure the multicast service.
a. Create an S-VLAN and add an upstream port to it.
The VlAN ID is 1000, and the VLAN type is smart. Add upstream port 0/19/0
to smart VLAN 1000.
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
b. Configure a traffic profile.
Run the display traffic table ip command to query existing traffic profiles in
the system. If the traffic profiles existing in the system do not meet the
requirements, you need to run the traffic table ip command to add a traffic
profile.
Set the profile ID to 10, the priority to 4 and no rate limitation on both the
upstream and downstream directions. In addition, configure the scheduling mode
so that packets are scheduled according to their priorities.
huawei(config)#traffic table ip index 10 cir off priority 4 priority-
policy
local-setting
c. Create a service port.
Set the service port indexes to 5 and 6, S-VLAN ID to 1000, C-VLAN ID to 30,
and the ID of the ONT ETH port connected to the user STB to 2. The traffic
profile 10 is used.
NOTE
If the STB interconnected to the ONT does not support VLAN tag, the user-side VLAN is set
to untagged when creating service port.
huawei(config)#service-port 5 vlan 1000 port 0/1/1 ont 1 eth 2 multi-
service
user-vlan 30 inbound traffic-table index 10 outbound traffic-table
index 10
huawei(config)#service-port 6 vlan 1000 port 0/1/1 ont 2 eth 2 multi-
service
user-vlan 30 inbound traffic-table index 10 outbound traffic-table
index 10
d. Configure the IGMP version.
Set the IGMP version of the multicast VLAN to IGMPv3.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v3
e. Create a multicast VLAN and select the IGMP mode.
Set the multicast VLAN ID to 1000 and select the IGMP proxy mode.
huawei(config-mvlan1000)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
715