Huawei SmartAX MA5603T Configuration Manual page 736

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
l
Procedure
l
Issue 01 (2014-04-30)
The interface data and the POTS user configuration data corresponding to the MG interface
is configured on the MGC.
Related configurations are performed on the BRAS according to the authentication and
accounting requirements for dialup users. For details about the configuration, see the
configuration guide.
The VLAN of the LAN switch port connected to the OLT is consistent with the upstream
VLAN of the OLT.
Configure the OLT.
1. Configure GPON ONT profiles.
GPON ONT profiles include the DBA profile, line profile, service profile, and alarm
profile. In the simplified mode, the default DBA profile, line profile, and service
profile are used. That is, these profiles do not need to be configured.
a. Add an ONT line profile
The default line profile 0 is used. In this profile, the default T-CONT 0 and T-
CONT 1 are created. T-CONT 0 is bound to the default DBA profile 2 (the fixed
bandwidth: 1 Mbit/s), and is used for the OMCI management channel. T-CONT
1 is bound to the default DBA profile 0 (the assured bandwidth: 8 Mbit/s, the
maximum bandwidth: 20 Mbit/s), and is used for the service channel. The DBA
profile bound to a T-CONT can be modified.
b. Add an ONT service profile
The default service profile 0 is used. In this profile, the capability set of the ETH
port and POTS port is set to adaptive by default and therefore the OLT
automatically matches the number of ports according to the type of the online
ONT.
c. (Optional) Add an alarm profile.
– The default GPON alarm profile 1 is used. The alarm thresholds of the default
alarm profile are 0, which indicates that no alarm is generated.
– In this example, the default alarm profile is used, and therefore the
configuration of the alarm profile is not required.
– Run the gpon alarm-profile add command to configure a GPON alarm
profile, which is used for monitoring the performance of an activated ONT
line.
2. Add ONTs on the OLT.
The ONT is connected to a GPON port of the OLT by optical fibers. The service can
be configured only after ONTs are successfully added on the OLT.
Two ONTs are connected to GPON port 0/1/1. The ONT IDs are 1 and 2, SNs are
32303131D659FD40 and 6877687714852901, passwords are 0100000001 and
0100000002, the discovery mode of passwords is once-on, and the management mode
is OMCI.
a. Add ONTs offline.
If the password of an ONT is known, run the ont add command to add an ONT
offline.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
711