Configuring Link Aggregation, Congestion Control, And Security Policy - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

11.3.4.12 Configuring Link Aggregation, Congestion Control, and Security Policy

The global configuration of upstream link aggregation and queue scheduling based on priorities
ensures service reliability. The global configuration of security policies ensures service security.
Context
Link aggregation provides a higher bandwidth and uplink reliability for optical line terminals
(OLTs) by aggregating multiple uplink Ethernet ports to one link aggregation group (LAG).
Link aggregation is recommended.
Congestion control places the packets to be sent from a port into multiple queues that are marked
with different priorities. Then, the packets are sent based on queue priorities. Congestion control
is recommended.
Security policies ensure system, user, and service security.
NOTE
Enable a service security function based on the service type. For details, see
Plan.
Procedure
l
l
Issue 01 (2014-04-30)
– If HGWs are connected to an ONU upstream in VDSL2 mode, assume that the VDSL2
path mode is PTM mode, the user VLAN ID is 43, and the VDSL2 port is 0/1/0, and
add a service flow as follows:
huawei(config)#service-port 401 vlan 1000 vdsl mode ptm 0/1/0 multi-service
user-vlan 43 rx-cttr 10 tx-cttr 10
Configure a multicast user and add the user to the multicast VLAN.
Configure service flow 401 as a multicast user, add the user to multicast VLAN 1000, and
adopt the no-auth mode for the multicast user.
huawei(config-mvlan1000)#btv
huawei(config-btv)#igmp user add service-port 401 no-auth
huawei(config-btv)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp multicast-vlan member service-port 401
huawei(config-mvlan1000)#quit
Configure link aggregation.
The following configurations are used as an example to configure link aggregation:
– Uplink ports 0/19/0 and 0/19/1 are added to a LAG.
– The two ports send packets upstream based on the packets' source MAC addresses.
– The LAG works in Link Aggregation Control Protocol (LACP) static aggregation mode.
huawei(config)#link-aggregation 0/19 0-1 ingress workmode lacp-static
Configure queue scheduling.
According to quality of service (QoS) planning principles, all packets are scheduled in strict
priority (SP) mode and mapped to queues according to the packets' priorities. For details
about QoS planning principles, see
huawei(config)#queue-scheduler strict-priority
huawei(config)#cos-queue-map cos0 0 cos4 4 cos5 5 cos6 6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
11.2.2 Principle of QoS Data
11.2.7 Principle of Security Data
Plan.
1009