Ethernet Parameter - Mitsubishi Electric MELFA CR750 Series User Manual

11.6.2. Ethernet parameter

You can set robot controller Ethernet information.
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Communication parameter] ->
[Ethernet].
The "Ethernet" screen is different with versions of this software.
(1) In the case of using version 3.00A or later
Click a menu. The screen corresponding to the selected menu is displayed.
After you change the parameter value, you can rewrite the parameters in the robot controller by clicking the
[Write] button.
You can reference explanations of displayed parameters by pressing the [Explain] button.
11.6.2.1. IP address
You can set the parameters related to IP address in the robot controller.
Figure 11-56 Ethernet parameter – IP address (Version 3.00A or later)
You can copy network settings of the computer to the screen by clicking the [Copy PC network settings]
button.
11-201 11-201