Mitsubishi Electric MELFA CR750 Series User Manual page 404

17.3.6.7. Layout condition edit
"Layout condition edit" screen is shown by clicking [Edit] button on "Layout edit" screen.
If you set I/O states to the layout parts, you can show or hide the parts. This function can be used in
simulation.
(1)
(2)
(3)
If you set no condition, select [Default]. If you set some conditions, select [I/O (Valid only in simulation)].
(1) ON->OFF
(2) OFF->ON
(3) Condition
(4) I/O type
(5) Start signal #
(6) Bit size
(7) Signal value
(8) Project
17-404
(4)
Figure 17-41 Layout condition edit
Set conditions from "show" state to "hide" state. The conditions can be set until 3.
When all conditions are met, the layout parts are hidden.
Set conditions from "hide" state to "show" state. The conditions can be set until 3.
When all conditions are met, the layout parts are shown.
If you checked [Enable], you can set the condition.
Check same number to set conditions.
Select [input signal], [output signal], [Register (CC-Link) Input], [Register (CC-Link)
Output].
Set 0 or larger when you select [input signal] or [output signal].
Set 6000 or larger when you select [Register (CC-Link) Input] or [Register
(CC-Link) Output].
Set 1 - 32 when you select [input signal] or [output signal].
Set 1 - 2 when you select [Register (CC-Link) Input] or [Register (CC-Link) Output].
Set the value which is compared with I/O state.
Set the unsigned decimal value which is expressed in binary value with bit size
specified (6) when you select [input signal] or [output signal].
Set the signed decimal value which is expressed in binary value with 1 register (16
bit) or 2 register (32 bit) specified (6) when you select [Register (CC-Link) Input] or
[Register (CC-Link) Output].
Set the target project to check I/O status when you use 3D monitor for multiple
projects. You need not to set this when you use 3D monitor for a project.
(5) (6) (7) (8)
17-404