Got Communications Settings - Mitsubishi Electric MELFA CR750 Series User Manual

6.2.4. GOT Communications Settings

The GOT Communications is the method to connect with the CR750-D/CRnD-700 series controller by using the
RS-232 / USB on the GOT which is connected with the controller via Ethernet.
GOT Communication can be
Item
COM (*1)
Baud (*1)
Network No.
Station No. (PC side
I/F setting)
Controller IP address
Station No. (Robot
controller side
setting)
Check
communication time
(*1) COM and Baud are available only that RS-232 is selected.
6-81
used with this software Ver.1.5 or later.
Table 6-5 GOT Communication Setting Items and Default Values
COM1 - COM10 can be selected.
Select from 9.6Kbps、19.2Kbps、38.4Kbps、57.6Kbps、
115.2Kbps.
1 - 239 can be set. Be matched to Network No. of the
GOT.
1 - 64 can be set. Be matched to Station No. of the GOT.
Set a value different from the Station No. of Robot
controller side I/F setting.
Set the IP address of the controller connected with GOT.
1 - 64 can be set. Be matched to Station No. set by
I/F GOT.
at 1 - 9999 can be set. Set the timeout after transmits.
Note: If too short time is set, the timeout error occurs.
Explanation Default value
COM1
19.2Kbps
1
64
192.168.0.20
1
30 seconds
6-81