Mitsubishi Electric MELFA CR750 Series User Manual page 462

Option card
(1)
How should one check what option cards are mounted in a robot controller?
Check from the project tree.
For details, see "14 Option Card" in this document.
Parameter editing
(1)
No parameter list is displayed in the parameter editing tool.
Download the parameter list from the robot controller.
For details, see "11.1.4 Parameter list reading".
(2)
We changed a parameter, but the new value does not take effect.
After you changed the parameter, did you switch the power for the robot controller Off, then On again?
The new parameter value does not take effect until you switch the robot controller power Off, then On again.
Switch the robot controller power Off, then On again.
Backup/restore
(1)
Is it possible to edit a backed up program data with program editor?
In version 1.2 or later, it is possible to open a backed up program data with program editor. Please refer to
"8.2.4 Opening a program in the backup data" in this manual for details.
When you use the software Ver.1.1 or earlier, please restore the backed up program to robot controller,
then open it with program editor or copy it to the computer with program management, and edit it.
3D Monitor
It takes time to update the screen display.
(1)
It might take time to update the screen display when a lot of data displayed in 3D monitor. The time to
update the display of the screen when the displayed data is reduced shortens.
Moreover, when the performance of the computer is low, other screens may be unable to be displayed
during 3D monitor display.
If you selected the "Detailed model" of the robot, please change to "Simple model". Please refer to "5.7
Changing a Workspace" in this manual for details.
The screen was not normally displayed. (For instance, the entire screen becomes black.)
(2)
Please click
Other
(1)
Characters are displayed on the screen on top of each other or with some characters missing.
Is the font size in the computer screen settings something other than "Standard"?
Use this software with the font size set to "Standard". For Windows XP, to make the screen settings, click
[Control Panel] → [Display]. Now from the "Display Properties" window's "Appearance" tab, set the font
size with [Font Size].
(2)
A program is not printed correctly.
In some printer types, tab characters into a program may be printed correctly.
Replace them with a space character with the program editing, or change a printer setting and use
TrueType font.
21-462
button of the toolbar.
21-462