Mitsubishi Electric MELFA CR750 Series User Manual page 56

Function
Password Setup
File Manager
2D Vision
Calibration
Option card
Tool
Force control log
viewer
User definition screen
Oscillograph
DXF File Import
Simulation
Same functions as
online
Tact time measurement
Backup, restore
MELFA 3D-Vision
I/O Simulator
Robot firmware update
(*1) This function can be used with Version 1.4 or later of this software.
(*2) This function can be used with Version 1.5 or later of this software.
(*3) This function can be used with Version 2.00A or later of this software.
(*4) This function can be used with Version.2.10L or later of this software.
(*5) This function can be used with Version 2.20W or later of this software.
(*6) This function can be used with Version 2.40S or later of this software.
(*7) This function can be used with Version 3.00A or later of this software.
(*8) This function can be used with Version 3.10L or later of this software.
(*9) This function can be used with Version 3.20W or later of this software.
(*10) This function can be used with Version 3.30G or later of this software.
(*11) This function can be used with Version 3.40S or later of this software.
4-56
The password to limit controller's right of access is registered, changed or
deleted. (*3)
You can copy, delete and rename the file in the robot controller. (*5)
Run the 2D vision calibration.(*9)
You can check information on option cards mounted in the robot controller.
This function can display the graph of log data of force control in PC and
robot controllers.
It is possible to edit the user definition screen which can be operated by
highly efficient T/B. (*5)
The data of a robot controller is displayed in a graph. (*7)
Import the DXF files can be converted into a robot program / spline file.
(*11)
This can be used connected with a virtual robot.
*This can only be used with the standard edition.
The same functions can be used with a virtual robot controller as with an
online one.
The tact time for the robot program with the specified contents can be
measured in the simulation.
You can back up the information in the robot controller and restore backed
up information into the controller.
You can do a setup of MELFA-3D Vision. (*7)
Simulates the signal communication between robots.(*9)
You can update the firmware of the robot controller.(*10)
Since this function is a function for maintenance, not open to the public.
Explanation
4-56