Line Number Conversion (From Melfa-Basic Iv To Melfa-Basic V) - Mitsubishi Electric MELFA CR750 Series User Manual

8.12.2. Line number conversion (from MELFA-BASIC IV to MELFA-BASIC V)

Convert the lines No. and relevant command line, because the deal of line No. in MELFA-BASIC IV is different
from MELFA-BASIC V.
For the MELFA-BASIC V, convert as follows.
- The line No. is converted to the step No. (sequential No. which starts from 1).
100 MOV P1
110 MVS P2
120 MOV P3
:
- The command line using line No. jump is converted to the command line using label jump.
100 MOV P1
110 MVS P2
120 GOTO 100
:
Convert the program according to the following procedure.
Figure 8-73 Conversion from MELFA-BASIC IV to MELFA-BASIC V
(1) Select the program language of the source and target for conversion.
Start program conversion with the project set with "MELFA-BASIC V"
Choose "MELFA-BASIC IV" for the source and choose "MELFA-BASIC V" for the target.
It is NOT necessary to select the axis of robot.
8-145
1 MOV P1
2 MVS P2
3 MOV P3
:
1 *LB00001 : MOV P1
2 MVS P2
3 GOTO *LB00001
:
*LB00001 is the label name created automatically by this conversion.
(1)
(2)
(3)
(4)
8-145