Mitsubishi Electric MELFA CR750 Series User Manual page 225

(7) Changing variables
You can change the values of variables registered on the variables monitor.
On the variables monitor, select the variables to change the values, then click the [Change] button.
After confirming the variable name, input the value of the variable, then click the [OK] button.
Caution
Be careful when changing the value of a variable.
When you change the value of a variable, the operation target position of the robot may change and
result in a collision. This is particularly dangerous during robot operation, so check carefully before
changing the value of a parameter.
(8) Load
You can load variables to be monitored on the variables monitor from a file.
When you click the [Load] button, you can load variable names and variable types and add them as
variables to be monitored.
(9) Save
You can save as a file a list of the variables being monitored on the variables monitor.
When you click the [Save] button, you can save the names, types, and values of the variables currently
being monitored into a file. This file is saved in text format.
12-225
Figure 12-5 Changing Variable Values
12-225