Mitsubishi Electric MELFA CR750 Series User Manual page 88

6.2.5.5. When Ethernet is selected
When "Ethernet" is selected as the computer interface, the communications routes that you can select are as
follows.
Table 6-9 Communications Routes That Can Be Selected for "Ethernet"
No.
1 Ethernet board communication Access other station via Ethernet module
2 Ethernet board communication Access Ethernet-serial communication other
station via Ethernet module
3 Ethernet board communication Access Ethernet-CC-Link other station via
Ethernet module
4 Ethernet port direct communication PLC module connection
5 Ethernet port direct communication Access serial communication other station
via PLC module
6 Ethernet port direct communication Access CC-Link other station via PLC
module
7 Ethernet port IP address designate communication PLC module connection
8 Ethernet port
communication other station via PLC module
9 Ethernet port IP address designate communication Access CC-Link other
station via PLC module
Figure 6-10 Ethernet (Ethernet board communication Access Ethernet-serial communication other station via
For some communications routes that you can select, "(1)PC side I/F Ethernet board setting", "(2)Network
communication route setting Ethernet", "(5)Network communication route setting of MNET/10" and
"(6)Coexistence network route setting of C24" can not be set.
6-88
Communications Route
IP address designate
Ethernet module) Detailed Settings
communication Access
Special mention
Ver.1.2 or later
serial
6-88