Tool Parameter - Mitsubishi Electric MELFA CR750 Series User Manual

11.3.5. Tool parameter

Set the standard tool coordinates and standard base coordinates. Set parameters while connected to the
robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Movement parameter] ->
[Tool].
After you change the parameter value, you can rewrite the tool parameters in the robot controller by clicking
the [Write] button.
11-171
Displayed when you are connected to a
controller that supports position repair.
Figure 11-14 Tool parameter
The switch of the tools is displayed in
version 1.8 or later of this software.
11-171