8.11.5. Rename
A program file name is renamed.
Select the name of the only one program to be renamed from the lists. The program can be selected at the
both lists. Rename is executed when the [Rename] button is clicked on and a new file name is set at the
[Setup for ReName] dialog.
A program which is set "Reading protection" can't be renamed.
8.11.6. Protect settings
The program files in the controller can be protected. The entire program file can be protected, or just the
command statements or position variables can be protected, or reading program can be protected.
You cannot move, delete, or rename a protected file. Release the protection before any of these operations.
Select the names of the programs to be protected from the lists. The multiple programs can be selected at
the same time. The programs can be selected at the both lists. Protect is executed when the [Protect] button is
clicked on and [Setting for protect] dialog is set.
Caution
The only programs to which protect operations apply are programs in robot
controllers.
If you change the state of "Reading protection", following "Register a reading password" or "The reading
password delete" screens are displayed. Click [OK] button after inputting a password to register or delete.
8-141
Figure 8-67 Rename Screen
Figure 8-68 Protect Settings Dialog
8-141