Mitsubishi Electric MELFA CR750 Series User Manual page 239

12.2.2.2. Deleting a named signal
Select the signals to delete from the list. You can select multiple signals by clicking them while holding down
the [Ctrl] key or the [Shift] key on the keyboard.
However, dedicated input/output signals can not be deleted.
Also, you can not delete input signals and output signals at the same time. Finally, delete the select signals
in the list with a mouse click.
12.2.2.3. Named signal definition information reading
When you click the [Load] button, a message asking you to confirm that you want to delete a registered
general input/output signal is displayed.
This message asks you to confirm that you want to clear the current general input/output signal display.
Figure 12-25 Deletion Confirmation Message for Registered General Input/Output Signal
If you select [Yes] on this confirmation screen, the "Select locate" screen asking you to select the load
source is displayed.
Select the device to load from, then click the [OK] button.
If you select the local device, the screen for selecting a file in the computer is displayed.
If you select the robot controller, the named signal definition file is loaded from the robot controller.
12.2.2.4. Saving definition information for named signals to a controller
When you click the [Save] button, the "Select locate" screen asking you to select the save destination is
displayed.
Select the device to save to, then click the [OK] button.
If you select the local device, the screen for selecting a file in the computer is displayed.
If you select the robot controller, the named signal definition file is saved to the robot controller.
12-239
Figure 12-26 Device Selection
Figure 12-27 Device Selection
12-239