Signal Parameters; Output Signal Reset Pattern Parameter - Mitsubishi Electric MELFA CR750 Series User Manual

11.5.

Signal Parameters

11.5.1. Output signal reset pattern parameter

These parameters set the operation when resetting the general-purpose output signals such as the CLR
instruction and dedicated input (OUTRESET).
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Signal parameter] -> [Output
signal reset pattern].
Set a signal number, and then select one of [OFF]/[ON]/[Hold]. The value of the signal having the specified
number displayed in the list changes. After you changed the parameter value, you can rewrite the output
signal reset parameter in the robot controller by clicking the [Write] button.
Also, selecting a signal group (for example, "32-0") and then clicking the [Set] button changes 32 signals at
once.
You can reference explanations of displayed parameters by pressing the [Explain] button.
Caution
Read the parameter list of the connecting controller.
Use this screen after reading the parameter list file of the connecting controller. And you can see
the output signals corresponding to the function of the connecting controller. You can read the parameter
list file on the "Parameter list" screen.
11-194
Figure 11-43 Output signal reset pattern parameter
Figure 11-44 I/O reset pattern parameter setting
11-194