Notes Of When Rt Toolbox2 Is Used With Iq Works (Melsoft Navigator); Notes Of When Rt Toolbox2 Is Installed; Notes Concerning Workspace Operation - Mitsubishi Electric MELFA CR750 Series User Manual

3. Notes of when RT ToolBox2 is used with iQ Works
(MELSOFT Navigator)
There are some limitations when robot controller's workspace is made by using iQ Works(MELSOFT
Navigator) or RT ToolBox2 is started from iQ Works(MELSOFT Navigator). Please refer to the following notes
when you use iQ Works(MELSOFT Navigator).
RT ToolBox2 corresponding to iQ Works(MELSOFT Navigator) is version 2.00A or later.
3.1.

Notes of when RT ToolBox2 is installed

Please input product ID attached to the product again when you install a
Notes 1-1：
standard version of RT ToolBox2 in the personal computer in which "iQ
Works(MELSOFT Navigator" is installed.
When RT ToolBox2 is installed in the personal computer in which "iQ Works(MELSOFT Navigator)" is
installed, product ID for "iQ Works(MELSOFT Navigator)" is displayed on "Input Product ID" screen. RT
ToolBox2 is installed in the personal computer as mini version when this software is installed with this
Product ID. Please input product ID attached to RT ToolBox2 product again when you install a standard
version of RT ToolBox2.
3.2.

Notes concerning workspace operation

The workspace name and the workspace title cannot be changed.
Notes 2-1：
When RT ToolBox2 is started from iQ Works(MELSOFT Navigator), the workspace name and the
workspace title cannot be changed.
displayed in the gray and cannot be selected. (Refer to "Figure 3-1 Menu of [Workspace] and
Dropdown-menu of the Workspace")
Please close RT ToolBox2 once when you edit another workspace.
Notes 2-2：
The another workspace cannot be opened after closing the editing workspace when RT ToolBox2 is
started from iQ Works (MELSOFT Navigator). [New] of the [Workspace] menu and [Open] are displayed
in the gray, and cannot be selected. (Refer to "Figure 3-1 Menu of [Workspace] and Dropdown-menu
of the Workspace")
ToolBox2 specifying another workspace from iQ Works(MELSOFT Navigator).
It is not possible to save as another name when the workspace is edited.
Notes 2-3：
The editing workspace cannot be saved as another name when RT ToolBox2 is started from iQ Works
(MELSOFT Navigator). [Save As] in [Workspace] menu is displayed in the gray and cannot be selected.
Figure 3-1 Menu of [Workspace] and Dropdown-menu of the Workspace
3-52
"Edit workspace" in the dropdown menu of the workspace name is
When you edit another workspace, please exit RT ToolBox2 once and start RT
Menu of [Workspace]
Dropdown-menu of Workspace
(online)
3-52