Mitsubishi Electric MELFA CR750 Series User Manual page 116

8.6.4.10. Partial writing
Writes the selected program lines to the robot controller.
This is handy for reflecting the contents of the partially revised program in the robot controller, but be careful.
Only the selected part of the program is written.
Select the lines to be written to the robot controller, then click on the menu bar [Edit] -> [Partial Write].
Check the contents to be written, then click [Yes].
8.6.4.11. Transfer all lines of the program
Write the all lines of the program to the robot controller.
Click on the menu bar [Edit] -> [Transfer all to the controller] after opening the program. After displaying the
confirmation message, and then click "Yes".
This function can be used with version 1.6 or later of software.
8-116
Figure 8-34 Partial Writing
8-116