Cisco SR2016T-NA Reference Manual page 90

cable enable-trap
cable enable-trap
To permanently set four
a CM changes between the online and offline states, use the cable enable-trap command in cable
interface configuration mode. To return to the default settings found in the MIB, which disable the
sending of these traps, use the no form of this command.
Syntax Description cmonoff-notification
cmonoff-interval
time-in-secs
Defaults
The default is to use the MIB defaults, which specify that traps are not to be sent, with an interval value
of 600 seconds (10 minutes).
Command Modes
Interface configuration (cable interface only)
Command History Release
12.0(13)SC
12.1(5)EC1
12.2(4)BC1
Usage Guidelines This command sets four attributes in the
automatically loaded whenever the CMTS router powers on or reloads. To do so, put the appropriate
commands in the configuration file and save it to the CMTS router's Flash memory. The CMTS router
automatically sets the appropriate MIB values when it processes the configuration file at startup.
These commands affect whether the CM online/offline notification trap (cdxCmtsCmOnOffNotification)
is sent, and if so, the minimum interval that must exist between traps that are sent for the same CM
undergoing the same state changes. The following describes the relationship between these commands
and the attributes in the CISCO-DOCS-EXT-MIB MIB:
•
•
Cisco Broadband Cable Command Reference Guide
2-78
CISCO-DOCS-EXT-MIB MIB
cable enable-trap [cmonoff-notification | cmonoff-interval time-in-secs]
no cable enable-trap [cmonoff-notification | cmonoff-interval]
Modification
This command was introduced.
This command was added to the 12.1 EC train and support was added for the
Cisco uBR7100 series routers.
This command was added to the 12.2 BC train and support was added for the
Cisco uBR10012 router.
The cable enable-trap cmonoff-notification command sets the cdxCmtsCmOnOffTrapEnable
attribute to 1 (true), which enables the sending of the CM online and offline traps.
The no cable enable-trap cmonoff-notification command sets the cdxCmtsCmOnOffTrapEnable
attribute to 2 (false), which disables the sending of the CM online and offline traps.
attributes that enable the sending of a trap when
Enables or disables the sending of the notification traps.
Specifies the minimum interval that must pass before sending out a
new trap for the same CM.
Specifies the number of seconds (0 to 86400 seconds). The default
value is 600 seconds.
CISCO-DOCS-EXT-MIB
Chapter 2 Cisco CMTS Configuration Commands
MIB, so that the new values can be
OL-1581-08