Cisco SR2016T-NA Reference Manual page 36

cable clock force
cable clock force
To select the external timing source when the clock card is in holdover mode, use the cable clock force
command in global configuration mode. To disable the selection and return to the default, use the no
form of this command.
Syntax Description primary
secondary
Defaults
The clock card automatically uses the primary external source, if available. If the primary source fails,
the clock card enters holdover mode and, after a few seconds, switches to the secondary external source.
The clock card switches back to the primary source when it becomes available.
Command Modes Global configuration
Command History Release
12.1(1a)T1
12.1(2)EC1
Usage Guidelines This command overrides the default behavior of the clock card when the clock card is in holdover mode.
If the clock card is not in holdover mode, this command is ignored. You cannot force the reference to a
port if the clock card is in free-running mode.
This command is not applicable on the SC train.
Note
The clock card enters holdover mode if the forced reference is lost, even if the other external reference
Note
is available.
To support the clock feature set in VoIP configurations, a Cisco uBR7246 VXR chassis, equipped with
a clock card; and a Cisco uBR-MC16S, a Cisco uBR-MC16E, or a Cisco uBR-MC28C cable interface
line card must be used running Cisco IOS Release 12.1(1a)T1 or later releases. Only these cable
interface line cards support the external clock card reference from a clock card to distribute that signal
to CMs or set-top boxes (STBs) attached to the specific network segments. You can use other cable
interface cards, such as the Cisco uBR-MC16C, with the clock card, but these other cable interfaces will
not synchronize their downstream SYNC messages with the external clock source.
Cisco Broadband Cable Command Reference Guide
2-24
cable clock force {primary | secondary}
no cable clock force
Forces the primary source to act as the clock reference.
Forces the secondary source to act as the clock reference.
Modification
This command was introduced.
This command was supported on the EC train.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08