Table of Contents
Advertisement
cable service-flow inactivity-timeout
cable service-flow inactivity-timeout
To set the amount of time a dynamic service-flow can be present in the system without any activity, use
the cable service-flow inactivity-timeout command in global configuration mode. To remove the
specification, use the no form of this command.
Syntax Description
minutes
Defaults
30 minutes
Command Modes
Global configuration
Command History
Release
12.1(3a)EC
12.1(4)CX
Usage Guidelines
Resources such as service identifiers (SIDs) and bandwidth are dynamically allocated by a CM using
Dynamic Service Addition (DSA) transaction. If the CM fails to release these resources by issuing a
Dynamic Service Deletion (DSD), then the resources might be locked indefinitely. Use this command to
release unused resources.
Examples
The following example shows how to set the inactivity timeout for dynamic service flows to 2 minutes.
Once this setting is specified, any dynamic SID that does not show any activity in 2 minutes will be
deleted.
Router(config)# cable service-flow inactivity-timeout 2
The following example shows how to set the inactivity timeout back to the default value of 30 minutes:
Router(config)# cable service-flow inactivity-timeout
Related Commands
Command
cable service flow
inactivity-threshold
cable qos permission
Cisco Broadband Cable Command Reference Guide
2-212
cable service-flow inactivity-timeout minutes
no cable service-flow inactivity-timeout
Specifies service-flow inactivity-timeout in minutes. Valid range is 1 to 120
minutes. Default value is 30 minutes.
Modification
This command was introduced.
This command was replaced by the
command for DOCSIS 1.1 operation.
Description
Sets the amount of time a dynamic service-flow can be present in the system
without any activity (DOCSIS 1.1 operation).
Specifies permission for updating the cable router QoS table.
Chapter 2
Cisco CMTS Configuration Commands
cable service flow inactivity-threshold
OL-1581-08
Advertisement
Table of Contents
