Cisco SR2016T-NA Reference Manual page 174

cable modem remote-query
cable modem remote-query
To enable and configure the remote-query feature to gather CM performance statistics on the CMTS, use
the cable modem remote-query command in global configuration mode. To disable the gathering of
CM statistics, use the no form of this command.
Syntax Description polling-delay
community-string
Defaults No default behavior or values
Command Modes Global configuration
Command History Release
12.0(7)XR, 12.1(2)T
12.1(2)EC1
12.2(4)BC1b
12.2(15)BC1, 12.2(15)CX
Usage Guidelines
Note With Cisco IOS Release 12.2BC and 12.1EC, difficulty has been observed when attempting to remove
the remote-query feature from the Cisco CMTS. The no form of this command does not remove the
cable modem remote-query once configured on the Cisco CMTS. This restriction applies to Cisco
uBR7100 series, Cisco uBR7200 series, and Cisco uBR10012 routers, and is being tracked as caveat
number CSCdy10666.
Cisco Broadband Cable Command Reference Guide
2-162
cable modem remote-query polling-delay community-string
no cable modem remote-query
Specifies the delay between each poll that the CMTS makes to collect
the CM statistics. When the CMTS completes one remote-query poll,
the CMTS waits this time period before beginning another poll. Valid
range is from 1 to 86,400 seconds, with a recommended default value
of 30 seconds.
Defines the Simple Network Management Protocol (SNMP)
community string.
Modification
This command was introduced.
Support for this command was added to the 12.1 EC train.
This command is not supported on Cisco IOS
Note
Release 12.1(3a)EC1 but is supported on Cisco IOS Release
12.1(4)EC and later 12.1 EC releases.
Support for this command was added to the 12.2 BC train.
The sysDescr field is now obtained for each cable modem when the
remote-query feature is enabled. (This value can be displayed using
the verbose option of the
Chapter 2 Cisco CMTS Configuration Commands
show cable modem command.
OL-1581-08