Table of Contents
Advertisement
cable modem max-cpe
cable modem max-cpe
To specify a maximum number of permitted hosts per modem (overriding the max-cpe value in the CM
configuration file), use the cable modem max-cpe command in global configuration mode.
Syntax Description
n
unlimited
Defaults
The max-cpe value provided in the configuration file will be used by the CMTS to limit the number of
hosts connected to a single CM (no cable modem max-cpe).
Command Modes
Global configuration
Command History
Release
12.0(10)SC, 12.1(2)EC This command was introduced.
Examples
The following example shows how to override the max-cpe setting in a CM configuration file:
router(config)# cable modem max-cpe unlimited
Usage Guidelines
The CMTS enables up to n number of hosts for a modem.When set to unlimited, or n is larger than the
max-cpe value in the configuration file of a CM, this command overrides the configuration file value.
When setting to unlimited or n is greater than the max-cpe value in the configuration file of a CM, the
Note
CM has to control the maximum number of hosts, and the DHCP server has to control the number of IP
addresses assigned to hosts behind a single CM.
Caution
Use of this command might open a security hole in the system by enabling denial of service attacks.
Specifically, it might enable a user to obtain a large number of IP addresses, thereby taking down the
entire network, after all the available IP addresses have been reserved by this single user.
Cisco recommends that, if this command is enabled, the number of IP addresses assigned to hosts behind
a single modem be strictly controlled by the DHCP server.
The Cisco CMTS uses three commands set the maximum number of hosts for a particular CM, for all
CMs on a particular cable interface, or for all CMs using the Cisco CMTS router:
•
•
Cisco Broadband Cable Command Reference Guide
2-156
cable modem max-cpe [n | unlimited]
Modification
cable modem
max-hosts—Sets the maximum number of hosts for a particular CM.
cable
max-hosts—Sets the maximum number of hosts for all CMs on a particular cable interface.
Specifies the configuration file value. Valid range is 1 to 255.
Specifies the maximum CPE value to be unlimited.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
