Cisco SR2016T-NA Reference Manual page 909

Chapter 5 Cisco CMTS Debugging Commands
Table 5-3
Field
SID value is....
CM mac address....
Timing offset is....
Power value is FE0, or 0 dB
Freq Error = ....
Freq offset is ....
Related Commands Command
debug cable dynsrv
debug cable interface
debug cable mac-protocol
debug cable mac-scheduler
debug cable registration
debug cable tlvs
show controllers cable
OL-1581-08
debug cable mac Command Field Descriptions
Description
Reports the service ID of the modem. The range is from 1 through
891. The information on this line should agree with the first line of
the return (that is, Ranging Modem with Sid...).
The MAC address of the specified CM.
The time by which to offset the frame transmission upstream so that
the frame arrives at the expected minislot time at the CMTS.
The raw value derived from the 3137 Broadcom chip. Alternatively,
the dB value specifies the relative change in the transmission power
level that the CM needs to make sure that transmissions arrive at the
CMTS at the desired power level.
The raw value derived from the 3137 Broadcom chip.
Specifies the relative change in the transmission frequency that the
CM will make to match the CMTS.
Description
Displays debugging information about DOCSIS 1.1 dynamic service
flow messages.
Enables debugging output for a specific cable interface.
Displays debugging output for the MAC layer protocol.
Displays debugging output for the MAC layer scheduler and
admission control activities.
Displays debugging output for the registration messages sent when a
CM comes online with the CMTS.
Enables debugging for the Type/Length/Value encodings (TLVs)
parsed by the DOCSIS 1.1 TLV parser/encoder.
Displays interface controller information for the specified slot.
Cisco Broadband Cable Command Reference Guide
debug cable mac-address
5-49