Table of Contents
Advertisement
cable telco-return spd password
cable telco-return spd password
To set the password that the telco-return CM uses for authentication when establishing a PPP connection
with the access server, use the cable telco-return spd password command in cable interface
configuration mode. To restore the default value, use the no form of this command.
Syntax Description
spd-number
password-string
Defaults
No password is used.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the Login Password parameter for the specified SPD in Telephony Channel
Descriptor (TCD) messages.
This command is available only in images that support telco-return. These images have a "t" as part of
Note
the image name.
Examples
The following example shows how to set the password to 9JwoKd7 in service provider descriptor 2:
router(config-if)# cable telco-return spd 2 password 9JwoKd7
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
Cisco Broadband Cable Command Reference Guide
2-266
cable telco-return spd spd-number password password-string
no cable telco-return spd spd-number password
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
Login password that the CM uses for authentication during the
initialization procedure.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
