Cisco SR2016T-NA Reference Manual page 264

cable telco-return interval
cable telco-return interval
To set the interval for sending Telephony Channel Descriptor (TCD) and Termination System
Information (TSI) messages, use the cable telco-return interval command in cable interface
configuration mode. To restore the default value, use the no form of this command.
Syntax Description seconds
Defaults 2 seconds
Command Modes
Interface configuration (cable interface only)
Command History Release
12.0(4)XI
Examples The following example shows how to set the TCD and TSI message interval to 40 seconds:
router(config-if)# cable telco-return interval 40
Note This command is available only in images that support telco-return. These images have a "t" as part of
the image name.
Related Commands Command
cable telco-return enable
cable telco-return
registration-ip
cable telco-return spd dhcp-
authenticate
cable telco-return spd dhcp-
server
cable telco-return spd dial-
timer
cable telco-return spd
factory-default
cable telco-return spd
manual-dial
Cisco Broadband Cable Command Reference Guide
2-252
cable telco-return interval seconds
no cable telco-return interval
Number of seconds between intervals for sending TCD and TSI
messages. Valid range is 2 through 60 seconds.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Selects a different IP address for the telco-return CM to send its
registration requests.
Indicates that telco-return CMs must use a specific DHCP server.
Identifies the IP address of the DHCP server that the telco-return CMs
must use.
Sets the number of seconds that a telephone connection is idle before
the telco-return CM disconnects the call.
Indicates the service provider descriptor (SPD) that the telco-return
CM uses during the initialization process.
Enables the telco-return CM to operate in manual-dial mode.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08