Cisco SR2016T-NA Reference Manual page 746

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

show packetcable event

To display information the PacketCable event message (EM) server, use the show packetcable event

command in user EXEC or privileged EXEC mode.

Syntax Description

radius-server

Command Modes

User EXEC, Privileged EXEC

Command History

Usage Guidelines

This command displays information about the authentication, authorization, and accounting (AAA)

servers that are configured on the Cisco CMTS router for PacketCable operations. These include DF

servers (used for CALEA redirection of event messages and traffic), RADIUS servers (used for

authentication), and RKS servers (used for billing).

The following example shows typical output for the show packetcable event df-group command, which

shows the IP address and UDP port of the DF server to which event messages are being forwarded for

CALEA electronic surveillance.

Router# show packetcable event df-group

The following example shows a typical display for the show packetcable event radius-server

command, which shows the IP address for each RADIUS server that is configured on the router for

PacketCable operations, along with the UDP port number that it is using.

Router# show packetcable event radius-server

Server-address Port

Cisco Broadband Cable Command Reference Guide

show packetcable event {df-group | radius-server | rks-group}

Displays information about the Communications Assistance for Law

Enforcement Act (CALEA) Delivery Function (DF) server groups that are

configured on the router.

Displays information about the EM Remote Authentication Dial In User

Service (RADIUS) servers that are configured on the router.

Displays information about the Record Keeping Server (RKS) groups that

are configured on the router.

Modification

This command was introduced for the Cisco uBR7246VXR and

Cisco uBR10012 universal broadband routers.

Cisco CMTS Show Commands

Broadband cable