Table of Contents
Advertisement
cable submgmt default
cable submgmt default
To set the default values for attributes in the Subscriber Management MIB (DOCS-SUBMGT-MIB), and
to enable Cisco Static CPE Override on the Cisco CMTS, use the cable submgmt default global
configuration command. To restore the original defaults, use the no form of this command.
Syntax Description
no
active
learnable
max-cpe cpe-num
filter-group
cm
cpe
downstream
upstream
group-id
Cisco Broadband Cable Command Reference Guide
2-244
cable submgmt default [active | learnable | max-cpe cpe-num]
no cable submgmt default [active | learnable | max-cpe cpe-num]
cable submgmt default filter-group {cm | cpe} {downstream | upstream} group-id
no cable submgmt default filter-group {cm | cpe} {downstream | upstream} group-id
When used with the active and learnable options, the no form of the
command sets the default attributes to false. When used with the max-cpe
and filter-group options, the no form of the command sets the attribute to 0.
Sets the docsSubMgtCpeActiveDefault attribute, which controls whether
the CMTS manages the CPE devices for a particular CM—when set to
TRUE, the CMTS enforces the MAX-CPE value and the implemented
filters. The no cable submgmt default active command sets the default
value to FALSE (the original default), which turns off CPE management at
the CMTS.
Sets the docsSubMgtCpeLearnableDefault attribute, which controls
whether the CMTS learns the CPE IP addresses for a particular CM—when
set to TRUE (the original default), the CMTS learns IP addresses up to the
MAX-CPE value. The no cable submgmt default learnable command sets
the default value to FALSE, which means that the IP address for each
allowable CPE device must be specified in the DOCSIS configuration file.
Sets the docsSubMgtCpeMaxIpDefault attribute, which specifies the
default number of simultaneous IP addresses (CPE devices) permitted for
the CM. The possible range is 0 to 1024, where 0 specifies that all CPE
traffic from the CM is dropped. The default is 16.
Specifies a filter group, which can be applied to either upstream or
downstream traffic for either a CM or its CPE devices.
Specifies that the filter group applies to traffic to or from a CM.
Specifies that the filter group applies to traffic to or from a CPE device.
Specifies that the filter group applies to the downstream traffic that is going
to the specified CM or CPE device.
Specifies that the filter group applies to the upstream traffic that is coming
from the specified CM or CPE device.
Specifies the filter group ID (0 to 1024) to be applied for the CM or CPE,
downstream or upstream filter. This ID references the filter indexes that are
used for rows in the docsSubMgtPktFilterTable. A value of 0 indicates that
no filtering is used for this particular type of traffic.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
